Factory Default; System Data; Password; Control Device - Lorex L23WD Série Mode D'emploi

Factory Default

You can restore the system to the original
factory settings.
Restoring factory defaults will not
NOTE:
delete recorded video data.
To restore factory defaults:
1. Under FACTORY DEFAULT, click LOAD.
2. From the prompt, click OK to restore the
system to factory defaults.

System Data

You can save your system settings to a USB
flash drive for backup.
To save the system data:
1. Connect a blank USB flash drive to one of
the USB ports on the front panel of the
system.
2. Open the SYSTEM MANGEMENT menu.
Under SYSTEM DATA, click SAVE.
To load saved settings:
1. Connect a USB flash drive containing
saved system settings to one of the USB
ports on the front panel of the system.
2. Open the SYSTEM MANGEMENT menu.
Under SYSTEM DATA, click LOAD.

Password

Enable or disable the password prompt when
opening system menus.
To enable/disable the password:
1. Under PASSWORD, click
ON/OFF to enable/disable the system
password.
2. Click APPLY to save your settings or click
CANCEL to restore defaults.

CONTROL DEVICE

Use the Control Device menu to configure a
connected PTZ Keyboard (Pan Tilt Zoom
Camera Keyboard) (not included).
NOTE:
manual of your PTZ Keyboard to determine
the correct settings.
To configure control devices:
1. Click the CONTROL DEVICE tab on the left.
• The Control Device window opens.
Figure 13.5 Control Device menu.
2. Under SYSTEM ID, select from 1~255.
3. Under PROTOCOL, select D-MAX
(default),ICK-3000 MESA-KB, SIEMENS,
or GANZ.
NOTE:
device.
to select
4. Under BAUD RATE, select 19200, 9600,
4800, 2400,115200, 57600, or 38400.
5. Click APPLY to save your settings or click
CANCEL to restore defaults.
Using the System Menu
Please refer to your instruction
The Protocol must match the control
63