Changing Ptz Keyboard Settings; Configuring Recording Settings; Adjusting Pre And Post Alarm Duration - Lorex L23WD Série Mode D'emploi

Changing PTZ Keyboard Settings

To change your PTZ Keyboard settings:
1. Click Control Device in the sub-menu (System>Control Device). The Control Device Setting
window opens.
Figure 22.7 Control Device Setting window.
2. Under the System ID drop-down menu, select an ID between 00~255.
3. Under the Protocol drop-down menu, select desired protocol (D-MAX, Ganz, Simens,
Mesa-KB)
4. Click OK to save your settings.

Configuring Recording Settings

Adjusting Pre and Post Alarm Duration

To enable Pre and Post recording time:
1. Click Record on the navigation bar on the left. The Record Operation Setting window opens.
Figure 22.8 Record Operation Setting window.
2. Under the Pre Event Recording Time drop-down menu, select the duration of the pre-event
recording (0~5 seconds)
3. Under the Post Event Recording Time drop-down menu, select the duration of the post-event
recording (0~5 seconds)
4. Click OK to save your settings.
Using Web Remote Viewer
105