Alarm Schedule Activation - Lorex L23WD Série Mode D'emploi

• The camera parameter window opens.
Figure 16.12 Camera parameter window.
3. From the Camera Parameter window,
select and configure the following options:
• SIZE: Select from 352x240 (default),
704x240, or 704x480.
• FPS: Select from 1, 2, 3, 7, 15, or 30 (default)
frames-per-second (real-time recording)
from a shared pool of 127 FPS.
If the number of frames remaining in
NOTE:
the shared pool is a negative number you
will receive an error message. You will need
to adjust Size and FPS parameters to ensure
a positive number of frames remains in the
shared FPS pool.
• QUALITY: Select from LOW, STANDARD,
HIGH, HIGHEST (default) or SUPER.
• AUDIO: Select ON/OFF for the desired
channel(s)
The system can record a maximum of
NOTE:
four audio channels..
4. Click OK to save your settings.
Using the Recording Menu

Alarm Schedule Activation

After you set the camera parameters, you
must schedule what time and channel to
enable Alarm recording.
To activate and Alarm Recording:
1. Click the ACTIVATION tab near the top of
the window.
• The Alarm Activation grid opens.
Activation tab
Drag mouse cursor in the Alarm Activation grid
Figure 16.13 Alarm Schedule Activation window.
Any time blocks you have changed/
NOTE:
configured in the Camera Parameters
menu will appear in the Time Interval bar at
the top of the window.
2. Select the channel and time you wish to
enable Alarm recording by dragging your
mouse cursor in the Alarm Activation grid.
3. Click APPLY to save your settings.
4. Click CLOSE to exit.
79