Recording Schedule Activation - Lorex L23WD Série Mode D'emploi

4. Click OK to save your settings. The
Camera Parameters window closes and
the configured time block(s) change color.
Color in the Time Interval Bar
NOTE:
indicates that recording parameters have
been changed for the selected time block.
Colors are assigned randomly if you make
changes for different time blocks.
Figure 16.7 Changed time blocks.
5. Click APPLY to save your settings or click
CANCEL to restore defaults.
6. Repeat for different time blocks if
required.
Repeat steps 2~4 as required. Each
NOTE:
time block can have different camera
parameters.

Recording Schedule Activation

After setting the camera recording
parameters, you must activate Continuous,
Motion, or Continuous + Motion recording to
the selected channels.
To configure recording modes and set a
recording schedule:
1. Click the ACTIVATION tab near the top of
the window.
Using the Recording Menu
• The channel grid window opens.
Figure 16.8 Recording Modes/Schedule activation.
2. Select the channel and time you wish to
apply a recording type to by dragging your
mouse cursor in the grid window.
• The Event window opens.
Figure 16.9 Event window.
4. From the Event window, select
CONTINUOUS, MOTION, CONTINUOUS/
MOTION or NONE.
If you select NONE, the system WILL
NOTE:
NOT record during the selected time
block(s). Please use caution if applying
NONE to your recording schedule.
5. Click OK to save your settings.
77