Adjusting Ptz Settings - Lorex L23WD Série Mode D'emploi

Using Web Remote Viewer
2. Adjust Brightness, Contrast, Tint and Color by entering values between 0~100.
• To apply the same settings across all cameras, enter all values beside All.
3. Click OK to save the settings.

Adjusting PTZ Settings

To adjust PTZ camera settings:
1. Click the PTZ sub-menu (Camera> PTZ). The PTZ sub-menu opens.
Figure 21.3 PTZ settings menu.
2. Under CH Protocol select the desired PTZ protocol to use from the drop-down menu.
• The PTZ protocol choices are: PelcoD, pelcoP, MESA-DOME, D-Max, Fastraxll_2,
Ganz_PT_V3_2, Scc641, Scc643a, Spd_3300, Multix, MRX_1000, WV-cs850, WV-csr604,
PTC-400c, PTC-200, TAKEX, LPT-A100L.
3. Under Address Baudrate, select the desired baudrate from the drop-down menu.
• The Baudrate choices are: 2400, 4800, 9600, 19200, 384000, 57600, 115200.
4. Under Auto Focus / Auto Iris, select ON or OFF from the drop-down menu.
5. Under PT Speed / Zoom Speed, select values between 1~10 from the drop-down menu.
6. Under Focus Speed/ Iris Speed, select values between 1~10 from the drop-down menu.
7. Click OK near the bottom of the window to save your settings.
98