Display; Osd; Monitor - Lorex L23WD Série Mode D'emploi

DISPLAY

Configure the on-screen display
(OSD), monitor settings, Auto
Sequence, and Spot Out.

OSD

Use the OSD menu to customize the
appearance of the on-screen display, as well
as change the system language.
To configure OSD settings:
1. Click the SETUP button (
Status Bar.
2. Click SYSTEM SETUP.
3. Click DISPLAY.
• The Display window opens.
Figure 11.0 OSD menu.
4. Select OSD and press ENTER.
5. Customize the following:
• STATUS BAR TIMEOUT: Set the length of
time for the Status Bar to remain on-screen
(5 sec, 10 sec, 15 sec, 20 sec, 30 sec, 1 min,
or ALWAYS).
• CAMERA TITLE: Select ON/OFF to show or
hide the camera title.
• RECORDING MODE ICON: Select ON/OFF
to show or hide the recording mode icons.
• BORDER: Select ON/OFF to show or hide
channel borders.
• BORDER COLOR: Change the color of the
channel borders; select GRAY (default),
WHITE, RED, GREEN, BLUE, or YELLOW.
• MOTION SENSOR DISPLAY: Select ON/OFF
to show or hide the motion sensor display.
NOTE:
colored pixels that appear on-screen when
motion is detected by one of the cameras.
• MOTION COLOR: Change the color of the
motion sensor display; select BLUE
(default), YELLOW, RED, or GREEN
• LANGUAGE: Change the system language;
select ENGLISH (default), ITALIAN,
SPANISH, FRENCH, GERMAN, POLISH,
TURKISH, THAI, JAPANESE, CHINESE(S),
CHINESE(T), PORTUGUESE, BRAZIL,
DUTCH, GREEK.
6. Click APPLY to save your settings or click
) in the
CANCEL to restore defaults.

MONITOR

Use the Monitor menu to configure dwell times
and pop-up settings.
To configure monitor settings:
1. Click the MONITOR tab on the left.
• The Monitor window opens.
Figure 11.1 Monitor menu
2. Customize the following:
• SEQUENCE DWELL: Set the length of time
(in seconds) for each channel to appear
on-screen during Auto Sequence mode;
select from 1 sec, 2 sec, 3 sec, 5 sec
(default), 10 sec, 15 sec, 20 sec, 30 sec, 40
sec, or 60 sec.
• SPOT DWELL: Set the length of time (in
seconds) for each channel to appear
on-screen for the Spot Monitor (Spot Out);
select from 1 sec, 2 sec, 3 sec, 5 sec
(default), 10 sec, 15 sec, 20 sec, 30 sec, 40
sec, or 60 sec.
Using the System Menu
Motion Sensor Display refers to the
55