Recording Parameters - Lorex L23WD Série Mode D'emploi

Using the Recording Menu

RECORDING PARAMETERS

Parameters for each camera are set by hour
using the Time Interval bar at the top of the
window.
To set recording parameters for each channel:
1. Click the CONTINUOUS/MOTION
RECORDING tab on the left.
• The Continuous and Motion Recording
window opens.
Time interval bar
Figure 16.3 Continuous/Motion Recording window.
2. In the Time interval bar, drag the mouse
cursor to select the desired time you wish
to activate continuous / motion recording.
Drag mouse cursor to select duration
Figure 16.4 Selecting recording duration.
76
Figure 16.5 Error message due to negative frames remaining in
the shared FPS pool
• A Camera Parameter window opens.
Figure 16.6 Camera Parameter window.
3. From the Camera Parameter window,
select and configure the following options
for each channel of the selected time
block:
• SIZE: Select from 352x240 (default),
704x240, or 704x480.
• FPS: Select from 1, 2, 3, 7, 15, or 30 (default)
frames-per-second (real-time recording)
from a shared pool of 127 FPS.
If the number of frames remaining in
NOTE:
the shared pool is a negative number you
will receive an error message. You will need
to adjust Size and FPS parameters to ensure
a positive number of frames remains in the
shared FPS pool.
• QUALITY: Select from LOW, STANDARD,
HIGH, HIGHEST (default) or SUPER.
• AUDIO: Select ON/OFF for the desired
channel(s)
The system can record a maximum of
NOTE:
four audio channels.