Connecting Din Cameras - Lorex L23WD Série Mode D'emploi

Camera Installation

CONNECTING DIN CAMERAS

DIN cameras receive video, audio and power through a single DIN cable. The camera draws power
from the system it is connected to.
To install DIN cameras to your system:
1. Connect the female end of the extension cable to the camera.
Female connector
Extension Cable
Figure 2.7 Installing DIN cables.
The arrow on the DIN connector should both face up. This aligns the pins on the cable
NOTE:
and prevents the pins from being bent. If the pins are bent, the camera will not function.
2. Connect the male end of the extension to the DIN port in the system.
Figure 2.8 Connecting the extension cable.
12
Align arrows
Male Connector
Extension Cable