Configuring Alarm Output Settings - Lorex L23WD Série Mode D'emploi

Using Web Remote Viewer

Configuring Alarm Output Settings

To configure alarm output settings:
1. Click the Alarm Output sub-menu on the left navigation bar (Sensor>Alarm Output). The
Alarm Output Setting window opens.
Figure 25.2 Alarm Output window.
2. Under the Operation drop-down menu, select Enable or Disable to turn on or off alarm the
alarm output.
Figure 25.3 Close up of the Alarm Output Setting window.
3. Under the Mode drop-down menu, select Latched or Transparent.
• Latched alarms continually "beep" long after a camera detects motion. Transparent alarms
"beep" only when there is motion. Once the camera does not detect motion, the "beeping"
stops.
4. Under the Type drop-down menu, select N/O (normally open) or N/C (normally closed).
5. Under the HDD Event drop-down menu, select ON or OFF to enable or disable a hard disk
failure to send out an e-mail notification.
6. For each channel, select which events you want to trigger an alarm (Figure 38.4).
• For example, you may want a video loss and motion event in channel 2 to trigger an alarm.
7. Click OK to save your settings.
116
Grayed out by
default