Action Settings; E-Mail Notification; Behavior Settings - Lorex L23WD Série Mode D'emploi

Using the System Menu
You must select ENABLE in order to
NOTE:
configure action settings.
3. Under HDD EVENT, click
ON/OFF. If ON, an HDD event will trigger
an alarm output.
4. Under MODE, select TRANSPARENT or
LATCHED.
"Transparent" indicates the output is
NOTE:
active only when the trigger criteria (ie.
movement) is present. "Latched" indicates
the output is active for a set period of time
after a trigger.
5. If LATCHED is selected:
• Under DURATION, select 5 SEC (default),
10 SEC, 15 SEC, 20 SEC, 30 SEC, 40 SEC,
60 SEC, 120 SEC, 180 SEC, 300 SEC, or
Until Key (until a key is pressed on the
system).
In Latched mode, "Duration" refers to
NOTE:
the time that the alarm output remains
active after it has been triggered.

Action Settings

Set event triggers for each channel.
To configure action settings:
1. Set the following:
• ALARM: Select the box to enable the alarm
output when an alarm input is triggered
• VIDEO LOSS: Select the box to enable the
alarm output when video loss occurs on the
system
• MOTION: Select the box to enable the alarm
output when motion is detected on the
system
2. Click APPLY to save your settings or click
CANCEL to restore defaults.
72

E-MAIL NOTIFICATION

Use the Email Notification menu to configure
to select behavior and action settings for email
notifications to remote users. For details on
setting up email notification, see "Appendix D:
Enabling Email Notification" on page 148.

Behavior Settings

To configure behavior settings:
1. Click the E-MAIL NOTIFICATION tab on the
left.
• The E-mail Notification window opens.
Figure 15.4 E-Mail Notification menu.
2. Under NOTIFICATION, click
ON/OFF. If ON, the system will send an
email notification to selected users.
NOTE:
configure action settings.
3. Under SETUP CHANGE, click
select ON/OFF. If ON, the system will send
an email notification when changes are
made to the system settings.
4. Under HDD EVENT, click
ON/OFF. If ON, the system will send an
email notification when an event occurs on
the internal HDD.
5. Under BOOTING EVENT, click
select ON/OFF. If ON, the system sends an
email notification when the system is
powered on/off.
Action Settings
Set event triggers for each channel.
To configure action settings:
1. Set the following:
You must select ON in order to
to select
to
to select
to