Camera Installation; Camera Stand Installation - Lorex L23WD Série Mode D'emploi

CAMERA INSTALLATION

Before you mount the cameras , plug the camera into your system and test the image quality. Plan
where you will route the wiring for the camera and cables, and where you will aim the camera.
Installation Tips
1. Mount the camera away from direct and intense sunlight.
2. Plan your cable wiring so that it does not interfere with power lines or telephone lines.
3. Ensure that the camera wiring is not exposed and cannot be easily cut.
4. Mount the camera in an area that is visible, but out of reach.
5. In "high-risk" locations, have multiple cameras point in the same area. This provides camera
redundancy and different viewing angles.
6. Install the camera in an environment with an ambient air temperature of 14° F~113°F
(-10°c~45°c).

CAMERA STAND INSTALLATION

1. Mount the camera stand to the desired mounting surface. Choose a firm mounting surface.
If you wish to mount the camera stand to drywall, it is recommended to use drywall plugs
NOTE:
(not included).
2. Attach the camera to the stand.
*Camera model and stand may not be exactly as shown.
Figure 2.5 Camera mounting tips.
• There are two connection points for certain cameras. Secure the stand to the top thread for
wall-mounts or ceiling mounts. Secure the stand to the bottom thread for table-mounts.
Table Mount
Figure 2.6 Camera mounting options.
Top thread
(Ceiling mount, Wall mount)
Bottom thread
(Table mount)
Wall Mount
Secure to camera thread
Ceiling Mount
11