FLUVO WK Notice D'utilisation page 124

8.2 Fault assistance for type WKN
Important:
In accordance with UVV (Accident Prevention Regulations) all repairs and
!
intervention to the unit must be carried out exclusively by qualified persons
otherwise damage (accidents) could result to the user / operator.
Information:
i
The functional faults listed in the table are the most frequent causes of defects.
If the corrective measures described are not successful, then the specialist that
is called in individual cases will have to investigate the cause of the fault.
Attention:
If one or more LEDs are lit due to a fault then they do not go out when the
master switch is turned "OFF" and then "ON" again. The LEDs only go out
when the centrifugal pump is started up.
34
Information:
i
If the pump is connected to the power supply and no LED is lit up then the
pump is ready for operation. If the "ON" LED is illuminated then the pump is
operating and there is no fault.
After a functional fault, indicated by the LED, the pump is ready for operation
again after approx. 10 seconds. If the functional fault has not been remedied,
the LED will illuminate again and the pump switches off. After the functional
fault has been remedied and the pump has been re-started the LED goes out.
124 Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
OPERATOR'S MANUAL
Transmitter battery check
3-phase field monitoring
Dry run
Motor protection
Operation monitoring
Pumpe Typ WK / WKN
Version: 27220 - A
8202