ModelCraft GT3 2.4GHz Notice D'emploi page 58

Setting the EPA value for the throttle servo
Call channel 2 (CH2) for the driving function in the EPA menu for servo end
point adjustment (see above) with the cursor button (right/left).
Pull the operating lever for the drive function (see fig. 1, item 4) all the way to
the back towards the transmission handle and keep it in this position. The
running direction arrow changes to forwards (LF) in the display and the de-
fault value or the last programmed EPA value is displayed.
Now use the cursor button (up/down) to set the desired servo deflection for
full throttle. The EPA value can be set from 0 to 120%.
Now press the operating lever for the drive function forwards and keep it in
this position. The running direction arrow changes from the forward to back-
ward (BR) and the default or last programmed EPA value is displayed.
Now use the cursor button (up/down) to set the desired servo deflection for
braking. The EPA value can be set from 0 to 120%.
Press the Enter button to store the set value.
Use ESC to leave the programming menu again or to return to the operating
display.
Setting the EPA value for the additional servo
Call channel 3 (CH3) for the switching function in the EPA menu for servo end
point adjustment (see above) with the cursor button (right/left).
Move the switch for the additional channel (see figure 1, item 3) into the top/
front position). The running direction arrow changes to the left (LF) in the
display and the default value or the last programmed EPA value is displayed.
Now use the cursor button (up/down) to set the desired servo deflection to the
left. The EPA value can be set from 0 to 120%.
Move the switch for the additional channel to the lower/rear position. The
running direction arrow changes from the left to the right (RB) and the default
or last programmed EPA value is displayed.
Now use the cursor button (up/down) to set the desired servo deflection to the
right. The EPA value can be set from 0 to 120%.
Press the Enter button to store the set value.
Use ESC to leave the programming menu again or to return to the operating
display.
58
CH
EPA
100
CH
EPA
LF
96
CH
EPA
98
CH
EPA
100
CH
EPA
LF
115
CH
EPA
105
BR
%
%
BR
%
Figure 22
BR
%
%
BR
%
Figure 23