Allocating Functions For Rotary Controllers A And B - ModelCraft 20 65 01 Notice D'utilisation

If you have put [DR] on one switch, you can program two Dual Rate settings ([DR ON] / [DR OFF]) and then change
between the two data records by switching over.
When allocated with [NOR/ID], you can program two Throttle Curves and/or Pitch Curves, e.g. for normal flight and
aerobatics, and switch over on the transmitter directly in flight.
[ThroCut] is a simple switching function by which the motor can be switched off in flight in order to put the helicopter
into autorotation.
If when starting a flight the motor of the helicopter model does not start, check the position of
the toggle switch allocated with [ThroCut].
If it has been inadvertently switched on prior to starting, the motor will not start up.
f) Allocating functions for Rotary Controllers A and B
When preselecting a helicopter model, both rotary controllers can be directly allocated with the functions [NULL] (no
function) or [Pitch Adjust] (fine adjustment of the pitch function).
Pitch Adjust is equivalent to a trim function and shifts the mid-position of the pitch function to one or the other side,
depending on the controller's direction of rotation.
The default setting for the left rotary controller (B) is free. The right rotary controller (A) is to already be
allocated with [Pitch Adjust].
When preselecting a winged model, no selection is possible at this point.
In connection with setting one or more mixer functions, the rotary controllers can be allocated
with other functions both for winged models (e.g. superimposition of fowler flaps) and for heli-
copter models (e.g. gyro gain).
77
On the starting screen, press the [Switch A] or [Switch B] button.
Select the function you want to perform with the respective switch.
•
Confirm the selection with [OK].
•
On the starting screen, press the [VR (A)] or [VR (B)] button.
•
Select the function you want to perform with the respective rotary
•
controller.
Confirm the selection with [OK].
•