ModelCraft 20 65 01 Notice D'utilisation page 63

Programming via the PC software:
Error message:
2. DR (Dual Rate)
Programming via the control elements:
Switch the transmitter on.
•
Press the [Menu] and [Sel] buttons simultaneously.
•
[EP] appears as the first item in the Main Menu.
•
Use the [Sel] button to select the servo channel for which you want to
•
limit the end points.
The two directions are labelled [P] and [N] on the display.
•
Set the first value with the [+] and [-] buttons.
•
To switch from [P] to [N], move the respective control stick beyond the
•
centre position in the other direction.
Press the [Menu] button to save
•
The PC programming can be used to limit the end points of the servo
travels for Channels 1-6 between 0% and 120% in each direction.
On the starting screen, press the [EndPoint] button.
•
Enter through the keyboard the values desired for the two directions of
•
the respective end points.
Confirm the entries with the [OK] key.
•
To leave a menu item without any change or when you do not want to
adopt the changes, press the [Cancel] button.
This applies to all the menu items and will not be dealt with any further
in the following.
If an invalid value is entered (in this example value <0 or >120), an error
message will appear.
Confirm the error message with [OK].
•
Correct the value as instructed.
•
Confirm the entries with the [OK].
•
This applies to all the menu items and will not be dealt with any further
in the following.
Unlike the End-Point Adjustment (EP), the Dual Rate function sym-
metrically limits the maximum value of the respective function in both
directions. Doing this reduces the sensitivity of the control stick, because
with the same travel of the control stick, there is only a slight rudder
deflection.
The EP value set is altered by the same percentage.
At high speeds the model responds more sharply to rudder deflections.
Dual Rate Adjustment thus enables more delicate control of the model.
62