Commissioning The Receiver - ModelCraft 20 65 01 Notice D'utilisation

11. Commissioning the Receiver
Receiver connection
The receiver allows you to connect up to 6 servos and a receiver accumulator.
When connecting the servos or speed controllers, always make sure the polarity of the plug connectors is correct.
•
The plug contact for the signal line (yellow, white or orange depending on the manufacturer) has to be connected
•
on the left (inner) pin contact.
The plug contact for the negative line (black or brown depending on the manufacturer) has to be connected on the
•
right (outer) pin contact.
Assignment of the receiver channels to the control levers when the transmitter is delivered (Mode 2)
Channel
Ch 1 (Channel 1):
Ch 2 (Channel 2):
Ch 3 (Channel 3):
Ch 4 (Channel 4):
Ch 5 (Channel 5):
Ch 6 (Channel 6):
Bat:
How to assemble the receiver and the receiver module
The installation of the receiver depends on the model. For this reason, you should always follow the recommenda-
tions of the model manufacturer regarding receiver installation. Regardless of the model, you should always try to
install the receiver so that it is protected from dust, dirt, moisture and vibration in the best possible way. Two-sided
adhesive foam (servo tape) or even rubber rings that hold the foam-wrapped receiver securely in place are suitable
for fastening.
The receiver module has to be mounted such that its antenna is in a position perpendicular to
the antenna of the receiver.
Function
Ailerons (roll)
Elevators (nick)
Throttle
Rudder (tail)
Freely selectable
Pitch
Receiver battery
Control lever Direction
Right right/left
Right forward/backward
Left forward/backward
Left right/left
Left forward/backward
56