ModelCraft 20 65 01 Notice D'utilisation page 81

When multiple mixers are used, they influence one another.
If you put multiple mixers on the same target channel, the signals add up. This means that the
servos involved may arrive at the mechanical end stop before the respective control stick has
reached the maximum deflection.
In such case an EP or DR adjustment should be made for the target channel affected.
Menu subitems [Source] and [Des]:
Menu subitems [Up Rate] and [Down Rate]
In the menu subitem [Source], you determine the transmitter out-
put ([Source]), that is to be coupled to a receiver channel ([Des] =
Destination).
Channels 1-6 as well as Rotary Controllers VR A and VR B are available
as sources.
In the menu subitem [Des], you determine the receiver channel, that is to
be coupled to the source signal ([Source]).
Channels 1-6 of the receiver can be triggered as the destination
([Des]).
In the menu subitems [Up Rate] and [Down Rate], the mixing value for
the destination channel can be set in both directions.
Enter via the keyboard the values desired between -100% and
•
+100%.
When you have set all the mixers required and all the mixer parameters,
confirm the input with [OK].
80