ModelCraft 20 65 01 Notice D'utilisation page 69

Programming via the PC software:
2. EP (End-Point Adjustment)
Programming via the control elements and the PC software:
What is shown on the display and the programming correspond to that described for winged models under Main
Menu Item 1.
3. DR (Dual Rate)
Programming via the control elements and the PC software:
What is shown on the display and the programming correspond to that described for winged models under Main
Menu Item 2.
In the software, the values for each of the five items can be entered
directly.
The changed curve progression is simultaneously shown visually in a
diagram.
The selection of MODEL [NOR] and [ID] makes it possible to program
two different curve progressions, such as for normal flight (NORMAL)
and aerobatics (IDLE UP).
The two switch positions [ON] and [OFF] then correspond to the two
Throttle Curves selected.
If the switch has not been activated, then only the values saved
under [NOR] are available on the transmitter.
On the starting screen, press the [ThroCurv] button.
•
The default setting is MODEL [NOR].
•
Enter the desired values for the individual items.
•
Confirm the entries with the [OK].
•
If you have activated the toggle switch:
Select MODEL [ID]
•
Enter the values for the individual items.
•
Confirm the entries with the [OK].
•
Use the activated Toggle Switch [B] to switch between the two Throttle
•
Curves programmed.
68