ModelCraft 20 65 01 Notice D'utilisation page 74

Starting screen, winged model
Selecting the COM Port
An electronic system is integrated in the PC connecting cable, which simulates a COM port to
the computer instead of the USB connection actually used. This connection has to be called up
to establish the connection between the transmitter and the PC.
Without establishing this connection, the transmitter cannot be programmed.
Press the [Setting] button to select the COM port at which the system is connected to the PC.
•
This is generally COM 4.
Check the selection of the port by moving the remote control lever.
•
In the progress bar display, the bars should move according to the output signal of the respective channel.
•
If this is not the case, select a different COM port until the display responds.
Confirm the selection with [OK].
•
73
Starting screen, helicopter model