Switching On The Transmitter; Main Menu For Winged Models (Model Type 0) - ModelCraft 20 65 01 Notice D'utilisation

a) Switching on the transmitter
LCD display
When the transmitter is switched on the first time, the following information is shown on the display (c-f for
Mode 2):
The transmitter is factory preset to Model Type [0] (ACRO, aerobatic winged model).
a) Model type 0 = ACRO winged model
b) Battery voltage
c) Trim Channel 3 (throttle/pitch)
d) Trim Channel 4 (tail/rudder)
e) Trim Channel 2 (yaw/elevator)
f) Trim Channel 1 (roll/aileron)
The displays and screenshots shown in the following are examples of possible input.
b) Main menu for winged models (Model Type 0)
The settings described in the following can be made either using the control elements for the
transmitter or via the software that comes with the system.
More far-reaching programming of the transmitter has to be done on a PC using the software
included. (See the section „More far-reaching programming of the transmitter with the PC soft-
ware").
In addition, the allocation of functions for the transmitter's control elements can also be indivi-
dually set on a PC. Under some circumstances a mechanical alteration of the control sticks also
has to be made to do this.
59