ModelCraft 20 65 01 Notice D'utilisation page 65

Programming via the PC software:
4. SUB (Subtrim)
Programming via the control elements:
Programming via the PC software:
In the starting screen, press the [Reverse] button.
•
The default setting for the direction of rotation for all the servos is to
•
[NOR].
To change the direction of rotation, tick the space next to the servo
•
channel desired.
Confirm the input with [OK].
•
The Subtrim setting allows you to shift the mid-position of the individual
servos in addition to the setting via the Trim button on the transmitter.
The setting range is between +120 and -120.
Switch the transmitter on.
•
Press the [Menu] and [Sel] buttons simultaneously.
•
In the Main Menu, use the [Menu] button to jump to the item [SUB].
•
Use the [Sel] button to select the channel of the servo, the mid-positi-
•
on of which you want to shift.
A default value of [0] has been set for each servo channel.
•
Use the [+] and [-] buttons to select a value between +120 and -120
•
for the servo desired.
Press the [Menu] button to save
•
In the starting screen, press the [SubTrim] button.
•
Enter a value between +120 and -120 for the servo desired.
•
Confirm the entries with the [OK].
•
64