Transmitter Controls - ModelCraft 20 65 01 Notice D'utilisation

9. Transmitter controls
The transmitter comes with the left control stick allocated with the functions throttle/pitch and tail (gas/rudder), and
the right control stick with the functions yaw and roll (elevator/aileron) (Mode 2).
The allocation of the functions for the control elements can be changed via the software programming.
1. Transmitter antenna
2. Toggle switch A
3. Rotary controller VR A (e.g. Gyro Gain)
4. Control stick left, (Function Channels 4 and 3 throttle/pitch and tail)
5. Trim, Function Channel 4 (throttle/pitch)
6. Trim, Function Channel 3 (tail)
7. Ring for shoulder strap
8. [Menu] button
9. [sel] (select) button
10. LCD display
11. Handle
12. Toggle switch B (e.g. 3D switch)
13. Rotary controller VR B (e.g. pitch adjust)
14. Control stick right, (Function Channels 2 and 1, yaw and roll)
15. Trim, Function Channel 2 (yaw)
16. Trim, Function Channel 1 (roll)
17. Input button [+]
18. Input button [-]
19. Function switch
20. Charging socket (on side)
21. Bind button (rear side)
22. PC link (rear side)
23. Battery compartment (rear side)
52