Setting The Focus Point In The X- And Y-Axes - Fronius Laser hybride Instructions De Service

(8)
(8)
Setting the focus
point in the x- and
y-axes
Adjusting screws - left-hand view
Use adjusting screws (9), (10) and (11) to bring the focus of the pilot laser into the centre
of the crosshairs (1), as outlined in the following description:
84
(7) (7)
(11) (9)
NOTE!
Risk of components coming apart.
Loosen the four fastening screws but ensu-
re there is still no discernible play and the
parts are still noticeably held together.
Slightly loosen the four 5 mm fastening
5
screws on the optics system holder (7)
NOTE!
Risk of components coming apart.
Loosen the four 5 mm cheese head screws
(8) but ensure there is still no discernible
(8)
play and the parts are still noticeably held
together.
Slightly loosen the four 5 mm cheese
(8)
6
head screws (8) on the optics system
holder
(10)
Adjusting screws - right-hand view
(11)