Fronius Laser hybride Instructions De Service page 94

Item Designation
(4)
(5)
The inner liner for the LH hosepack is supplied in a 6.
5 m length.
When using LH hosepacks of a different length, the inner liner must exceed the LH hose-
pack by half a metre.
The wire drive parts in the scope of supply can also be ordered separately.
Do not replace any of the wirefeed components listed here with different versions.
In particular, using other V-groove rollers than those specified can cause severe problems
with wirefeeding.
Tools supplied with the LaserHybrid head:
Item Designation
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
94
Pressure roller
1.0/1.2/1.6 mm ... 42,0001,3465
Feed/pressure rollers (H-groove) for VR 1500 F++
Two drive rollers (aluminium: only the two front rollers)
Four drive rollers (steel)
VR 1500 K/4R/W/F++
1.0 mm (steel/CrNi/aluminium) ... 44,0001,1184
1.2 mm (steel/CrNi/aluminium) ... 44,0001,1185
1.6 mm (steel/CrNi/aluminium) ... 44,0001,1209
NOTE!
NOTE!
Flat spanner, 8/10 mm
42,0410,0004
Driving-gear spanner
42,0200,9344
Torch spanner (spanner for union nut)
42,0201,1215
Allen screwdriver, 3 mm (for protective glass)
42,0435,0005
Allen screwdriver, 4 mm (for setting the laser optics)
42,0435,0004
Allen key, 2.5 mm (for setting the laser optics)
42,0435,0002
Allen screwdriver, 5 mm (for setting the welding torch)
42,0435,0003
Allen key, 6 mm (for setting the position on the holder)
42,0435,0001
Extractor tool for dowel pins
44,0450,1223
Template for setting the focus point
42,0201,1216
Flat spanner, 12 mm
42,0410,0007
Pcs.
1
4
Pcs.
1
1
1
1
1
1
1
1
1
1
1