Safety Measures At The Installation Location; Safety Measures In Normal Operation - Fronius Laser hybride Instructions De Service

In addition to the operating instructions, any generally applicable and local regulations re-
garding accident prevention and environmental protection must be provided and followed.
All safety and danger notices on the LaserHybrid head must be kept in a legible condition.
Safety measures The cell for the LaserHybrid welding process must meet the following requirements:
at the installation -
location -
-
A device that topples over can easily kill someone. Place the device on a solid, level sur-
face.
-
Special regulations apply in rooms at risk of fire or explosion
-
Use internal directives and checks to ensure that the workplace environment is always
clean and clearly laid out.
Only set up and operate the device in accordance with the degree of protection shown on
the rating plate.
When setting up the device, ensure there is an all-round clearance of 0.5 m (1 ft. 7.69 in.)
to ensure that cooling air can flow in and out freely.
When transporting the device, observe the relevant national and local guidelines and ac-
cident prevention regulations. This applies especially to guidelines regarding the risks aris-
ing during transport.
Before transporting the device, allow coolant to drain completely and detach the following
components:
-
-
-
After transporting the device, the device must be visually inspected for damage before
commissioning. Any damage must be repaired by trained service technicians before com-
missioning the device.
Safety measures Only operate the LaserHybrid head if all protection and safety devices are fully functional.
in normal opera- If the safety devices are not fully functional, there is a risk of
tion -
-
-
Any safety devices that are not functioning properly must be repaired before switching on
the device.
Never bypass or disable safety devices.
Before starting up the LaserHybrid head, ensure that no one is likely to be endangered.
Check the LaserHybrid head at least once a week for obvious damage and proper func-
tioning of the safety devices.
be sealed off from adjoining rooms to make it lightproof
be screened with min. 1 mm thick steel plate and/or approved laser protective glass
to prevent any UV or laser radiation escaping
both the laser welding process and the arc welding process must stop automatically
as soon as the cell is opened
The maximum permissible tilt angle is 10°.
Observe relevant national and international regulations.
Wire feed speed
Wirespool
Shielding gas cylinder
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operator,
inefficient operation of the device.
67