Adjusting The Y-Axis - Fronius Laser hybride Instructions De Service

4
5
Adjusting the y-
axis
Setting the change of position in the y direction
1
2
3
4
5
A quarter turn corresponds to an adjustment distance of 0.25 mm.
A full turn corresponds to an adjustment distance of 1 mm.
Adjustment range ... +/- 2 mm
Tighten the fixing screws (2)
(Figure: Fixing screws for the coordinate axes)
Fit the housing cover
Remove the housing cover from the LaserHybrid head
Undo the fixing screws (3)
(Figure: Fixing screws for the coordinate axes)
Make the desired position adjustment using the adjusting
screw, as shown in the figure
A quarter turn corresponds to an adjustment distance of 0.25
mm.
A full turn corresponds to an adjustment distance of 1 mm.
Adjustment range ... +6/-1 mm
Reading accuracy using vernier ... 0.1 mm
Tighten the fixing screws (3)
(Figure: Fixing screws for the coordinate axes)
Fit the housing cover
Reading the change of position in the y direction
y
75