Publicité
2 8
SYSTEM
WAVEFORMS (CONTINUED)
TENS- Symmetrical Biphasic
Advice on size and type of electrodes to be used is
given in device GUI "treatment guidelines" feature
The Symmetrical Biphasic waveform has a short
pulse duration and is capable of strong stimulation
of nerve fibers in the skin and in muscle. This
waveform is often used in portable muscle
stimulation units, and some TENS devices.
Output Mode
Electrodes
Available on Channel
1,2
Treatment Time (Stim)
1-60 min
Treatment Time (Combo)
1-30 minutes
Mode Selection (Stim)
CC or CV
Mode Selection (Combo)
CV
Output Intensity
0-140 mA (CC) 0-140 V
(CV)
Amplitude Modulation
0% (off) to 100% on 10%
steps
Burst Frequency
0-10 bps
Cycle Time
Continuous or User Defined
Frequency
1-200 pps
Frequency Sweep
On/Off
Phase Duration
30-400 µsec
Ramp
0-5 sec
Sweep Time
14sec
Sweep Low Frequency
1-199 pps
Sweep High Frequency
2-200 pps
IRMS
0-50mA
DC component
No
INTELECT
MOBILE 2 USER MANUAL
®
TENS - HAN
Advice on size and type of electrodes to
be used is given in device GUI
"treatment guidelines" feature
The HAN Waveform provides optimal parameters
with a precisely controlled sequence of Dense-and-
Disperse (DD) modes of stimulation where a burst
of 8 pulses at 80Hz is alternating with continuous
stimulation (no burst), each lasting for 3 seconds.
Output Mode
Electrodes
Available on Channels
1, 2
Treatment Time
1-60 min
Mode Selection
CC
Output Intensity
0-100 mA (CC)
Burst Frequency
2 bps
Frequency
80 pps
Phase Duration
180 µsec
IRMS
0-19mA
DC component
No
Microcurrent
Advice on size and type of electrodes to
be used is given in device GUI
"treatment guidelines" feature
Microcurrent is a monophasic waveform of very low
intensity.
Output Mode
Electrodes
Available on channels
1, 2
Treatment Time
1-60 Min
Mode Selection
CC
Output Intensity
0-1,000 µA
Duty Cycle
50%
Frequency
0.1-1,000 pps
Polarity
Positive, Negative, or
Alternating
IRMS
0- 1mA
DC component
No
E N
Publicité
