Publicité
E N
CONNECTING CABLES AND
INSERTING PLUGS
When inserting the plugs, be sure to align the flat
side of the plug with the flat side of the slot and
push in gently. This is to avoid bending the pins
in the plug.
Insert cable into the appropriate connector prior to
starting therapy.
POWERING UP THE DEVICE
First time use always use mains power even if
battery connected. Insert the power cord into the
back of the unit, insert the plug into a power outlet,
do not position the Intelect® Mobile 2 in such a
way that makes it difficult to disconnect from the
mains power.
Switch device on with ON/OFF switch switch on
the back of the unit
1. The Initialisation screen below will be shown for
a few seconds whilst the device starts.
2. The first setup screen will be displayed after this
allowing the user to set language, device name,
time and choose patient pain scale as either NRS
SETUP INSTRUCTIONS
(Numerical Rating Scale) or VAS (Visual Analogue
Scale).
3. Click on "Continue" button to go to home screen
DEVICE CONNECTED TO THE
MAINS
1. Plug the Power cord into the back of device. Plug
the other end of the cord into an electrical outlet.
NOTE: The Power Cord may be unplugged from
the back of the unit in an emergency situation.
2. Turn on the ON/OFF switch located on the back
of the device.
3. Press ON/OFF button on LCD Front panel
4. Select desired function on the Home Screen
DEVICE WORKING ON BATTERY
1. Press the ON/OFF button on the LCD Front
INTELECT
MOBILE 2 USER MANUAL
®
21
Publicité
