Installation And Operation; Safety Instructions; Installation And Connection - Bartscher 116.402 Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
Connect the device to a properly installed and grounded single power socket.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
See that the cable does not touch any heat sources or sharp edges. Do not let the cable
o
dangle over the counter edge.
WARNING! Danger of burn!
During operation some parts of the device become very hot. In order to avoid injuries
do not touch any hot parts!
Do not use the device if it does not function properly, has been damaged or dropped.
o
Do not use any accessory or spare parts that have not been recommended by the
o
manufacturer. These can be dangerous for the user, or lead to damage of the device or
personal injury, and furthermore invalidate the warranty.
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep the
o
cable away from operating range and do not dunk it into water.
Do not move or tilt the device during operation!
o
WARNING! Hazard via electrical current!
The device may cause injuries due to improper installation!
Before installation, the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

ATTENTION!
Installation and maintenance operations may only be performed by qualified
professionals!
Installation
•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface.
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Position the device in such a way that the plug is easily accessible.
- 43 -