Publicité
4. Sweep the abrasive material into the opening above
the blast wheels.
5. Turn the blast wheels (A) by hand to push the
abrasive material out of the product and on to the
tarp.
A
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
24
A
Maintenance
Before you do
6. Do a check of the rubber seals in the valves for the
abrasive material. Refer to
seal in the valves for the abrasive material on page
31 .
7. Install the valves for the abrasive material.
Mandatory logbook for operation and
inspections
It is the responsibility of the operator to keep a logbook
in accordance with EN 1808:2015 Section 14.2.5. If the
ownership of the system changes, the logbook must be
kept together with the equipment. This information must
be included in the logbook:
•
The name of the competent person that is
responsible for the system.
•
The name of the operator and the date for each
operation of the product, the dust collector and the
rigging system.
•
Serial number of the product, the dust collector and
the rigging system.
•
Specifications of the steel wire ropes and the
operation hours.
•
Incidents and actions taken.
•
The date and results of these checks:
•
Safety checks before the first use
•
Weekly checks
•
Yearly checks
•
General overhauls
•
Repairs
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 8 .
To replace the rubber
Use personal protective
Personal protective
2149 - 001 - 02.11.2023
Publicité
