Publicité
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Turn the ON/OFF switch to ON postion.
3. Make sure that the power supply starts.
4. Turn the ON/OFF switch to OFF position.
5. Make sure that the power supply stops.
Emergency stop button
The emergency stop button is used to quickly stop the
motors.
To do a check of the emergency stop button
Product overview on page 3 for information
Refer to
about where the emergency stop button is on your
product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 19 .
3. Push the emergency stop button.
4. Make sure that the motors stop.
5. Turn the emergency stop button clockwise to
disengage.
Emergency stop button on the remote control
The emergency stop button is used to quickly stop the
motors.
CAUTION:
stop button on the remote control as the
stop button for the product.
To do a check of the emergency stop button on the
remote control
1. Turn the emergency stop button on the remote
control clockwise to make sure that it is disengaged.
2. Start the product. Refer to
page 19 .
3. Push the emergency stop button on the remote
control.
10
To start the product on
Do not use the emergency
To start the product on
4. Make sure that the motors stop.
5. Turn the emergency stop button on the remote
control clockwise to disengage.
Underpressure sensor
The underpressure sensor senses if there is sufficient
vacuum in the product to keep it to the surface. This
is indicated by the indicator for sufficent underpressure,
Remote control overview on page 4 . If there
refer to
is not sufficient vacuum, the underpressure sensor
immediately closes the valves for the abrasive material
and stops the motors.
To do a check of the underpressure sensor
1. Start the product. Refer to
page 19 .
2. Do a pairing operation between the remote control
and the product. Refer to
on page 18
3. Make sure that the indicator for sufficent
underpressure is OFF. Refer to
overview on page 4 .
4. Connect the dust collector to the product and start
the dust collector.
5. Make sure that the indicator for sufficient
underpressure comes on. Refer to
overview on page 4 .
Proximity switch
The proximity switch senses if the product is against the
surface. If the product releases from the surface during
operation, the proximity switch immediately closes the
valves for the abrasive material.
To do a check of the proximity switch
1. Connect and start the dust collector. Refer to
connect a dust collector on page 15 .
To start the product on
To do a pairing operation
Remote control
Remote control
To
2149 - 001 - 02.11.2023
Publicité
