Publicité
1. Push the button (A) to open the 2 valves for the
abrasive material at the same time.
B
2. Read the amperage values on the remote control
display (B).
3. If the 2 amperage values for the left and right blast
motor are not the same, adjust the valves for the
abrasive material with the 4 buttons (C).
4. Push the button (D) to close the 2 valves for the
abrasive material.
Abrasive material seal
The abrasive material seal makes sure that the abrasive
material stays in the product during operation. Vacuum
in the product holds the abrasive material seal against
the surface. The abrasive material seal has magnets
(A). Before operation it is necessary to fill the surface of
the magnets with abrasive material.
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive material on page 42 .
Refer to
14
Separator
The separator holds the abrasive material and supplies
the blast wheels with abrasive material.
A
To fill the product with abrasive
material
C
1. Stop the product. Refer to
D
2. Make sure that the valves for the abrasive material
3. Remove the hopper. Refer to
4. Fill the product with abrasive material to the
5. Do a check of the level of the abrasive material in
A
WARNING:
protective equipment during operation. Refer
Personal protective equipment on page 8 .
to
page 23 .
To operate the valves for the
are closed. Refer to
abrasive material on page 13 .
the hopper and the valves for the abrasive material
on page 29 .
maximum level. The maximum level is at the bent
plate in the separator.
CAUTION:
with abrasive material that has no
contamination.
the product regularly. Fill abrasive material when it is
necessary. Do the steps that follow:
Always use personal
To stop the product on
To remove and install
Only fill the product
2149 - 001 - 02.11.2023
Publicité
