Publicité
2. Set the speed control dial (A) on the remote control
to minimum speed.
A
B
3. Push the movement lever (B) on the remote control
forward to start the winch motors.
4. Push the steel wire ropes down until the winch
motors pull them through the winches.
WARNING:
hair away from the winch motors and the
steel wire ropes.
To align the abrasive material seal with
the surface
The rollers can be adjusted to make sure that the
abrasive material seal is parallel to the vertical surface
when the product hangs freely.
1. Move the product up a small distance. Refer to
do a test lift of the product on page 18 .
2149 - 001 - 02.11.2023
Keep clothing and long
To
2. Loosen the 2 nuts (A) and the bolt (B).
3. Adjust the loosened rollers until the abrasive material
seal is parallel to the surface and tighten the nuts
and the bolt.
To adjust the casters
The correct distance between the casters and the
surface is 10–20 mm/0.4–0.8 in.
1. Move the product up a small distance and align the
abrasive material seal with the surface. Refer to
align the abrasive material seal with the surface on
page 17 .
A
B
To
17
Publicité
