Publicité
General product maintenance
Clean the cooling system of the
electrical enclosure.
Replace the rubber seals of the
valves for the abrasive material.
Do the weekly maintenance of
the remote control.
Let a competent person do an in-
spection of the steel wire ropes.
Clean the filter and the hose of
the underpressure sensor.
Do a complete servicing of the
winches and safety devices.
Do a complete servicing of the
valves for the abrasive material.
Clean and do an inspection of all
motors.
Do a complete servicing and
cleaning of the product.
Do the yearly maintenance of the
remote control.
Let a competent person do an in-
spection of the winches and safe-
ty devices.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the cooling system of the
electrical enclosure
1. Disconnect the product from the power source.
2. Do a visual inspection of the cooling fans and the
outer surface of the heatsink.
26
Each 3 h
Daily
Each 50
Each 200
Each 250
h
h
X
X
X
X
*
O
3. Clean the heatsink with compressed air.
To drain water from the electrical
enclosure
Condensation from the cooling system drains in the
bottom right corner of the electrical enclosure. It is
necessary to do regular checks to make sure that the
water drains correctly.
Each 3
Yearly
h
months
O
O
2149 - 001 - 02.11.2023
O
O
X
Publicité
