Publicité
•
Steel wire rope with wire loops.
•
Steel wire rope with flattening caused by being
run over.
•
Steel wire rope with kink.
•
Steel wire rope with bend.
4. Replace the steel wire ropes if there are damages or
if the diameter is less than 10.0/0.39 mm.
To do maintenance on the winches and
the steel wire ropes
1. Lubricate the steel wire ropes regularly. Correctly
lubricated steel wire ropes supply the winches with
necessary lubrication.
CAUTION:
steel wire ropes with lubricants that
contain molybdenum disulphide (MoS2)
or PTFE. Use a standard multi-purpose
oil or grease.
28
Do not lubricate the
2. Use gear oil of the correct type to fill or replace the
oil in the gearbox of the winches. Refer to
data on page 41 .
3. Clean the winch motor housing if it is very dirty to
make sure that the winch motor does not become
too hot.
4. Make sure that there is no oil or grease on the motor
brake. The motor brake is only necessary to clean if
unusual operation conditions causes very much dirt.
To repair the winches
WARNING:
or DualLift GmbH or an approved service
center do repairs.
•
Use only original spare parts.
•
Refer to the service instructions for information how
to do the repairs.
•
Make notes of the repairs in the mandatory logbook.
Mandatory logbook for operation and
Refer to
inspections on page 24 .
To replace the abrasive material seal
1. Disconnect the proximity switch (A).
2. Remove the 12 rubber springs (B).
Technical
Only let the manufacturer
A
B
2149 - 001 - 02.11.2023
Publicité
