Publicité
set the ON/OFF switch to OFF. There is
remaining voltage in the product until the
power plug is disconnected.
1. Make sure that the product is disconnected from the
power source.
2. Remove the locking pins (A).
3. Tilt the support pipe for the dust extraction hose (B)
a small distance and lift to remove it.
4. Open the lid on the electrical enclosure.
32
A
B
WARNING:
carefully. The lid is heavy.
To do a complete servicing
The manufacturer must do a complete servicing each
200 h of operation but not later than each 4 years. The
first interval starts at delivery. The following intervals
start at each complete servicing.
•
Do the complete servicing at the manufacturer.
•
Make notes of the servicing in the mandatory
Mandatory logbook for operation
logbook. Refer to
and inspections on page 24 .
Yearly safety checks of the winches
Safety checks of the winches must be done each year
at a minimum by a competent person. The first interval
starts when the Husqvarna service center creates a
report at delivery. The following intervals start when
the safety checks are completed and noted in the
mandatory logbook.
Local regulations can have requirements for different
intervals of the safety checks. Additional safety checks
can be necessary in exceptional ambient conditions or
operation conditions according to the standards DGUV
Regulation 54, BGV D8, EN 1808 and EN 14492-1. This
must be agreed upon with the manufacturer and the
Husqvarna service center.
It is recommended to do the safety checks at the a
Husqvarna service center.
It is the responsibility of the operator to keep a logbook
in accordance with EN 1808:2015, section 14.2.5.
Open the lid very
2149 - 001 - 02.11.2023
Publicité
