Publicité
Problem
The product contin-
ues to move down
more than 20 cm/8
in. after the move-
ment lever is re-
leased.
The fault indicator is
on.
To move the product down manually in
an emergency
CAUTION:
down manually if the motor protection switch
has released because of overload.
CAUTION:
of the winches. If it is possible, do the
procedure on the winch on the other side
of the product at the same time. If only 1
person operates the system, lower 1 side
first in small increments to prevent damages
that can occur if the product tilts too much.
CAUTION:
minutes after each 30 m/98 ft. to let the
brake system become cool, if such a stop
does not cause a risk.
2149 - 001 - 02.11.2023
Cause
The brake is worn. The brake rotor is worn or
the air gap is incorrect.
The brake is wet.
The remote control is not connected to the
product.
The emergency stop is engaged.
The thermal switch on the winch motor re-
leased.
Do not move the product
The procedure shows 1
Stop the procedure for 5
Solution
Let an approved Husqvarna service agent do
the necessary repairs. Adjust the air gap cor-
rectly.
Make sure that the brake is dry and clean.
Remove the guard if it is necessary. Do not
continue the operation unless the brake op-
erates correctly.
Let an approved Husqvarna service agent do
the necessary checks and repairs.
Disengage the emergency stop button if
there is no emergency.
Wait 15 minutes to let the winch motor be-
come cool.
1. Remove the brake release lever.
37
Publicité
