Publicité
2. Loosen the clamp levers (A) that hold the control
cage in position.
3. Make a note of the position of the lateral window
indicator (B).
4. Look at the blast pattern.
5. If a hotspot must move to the right, move the
adjustment lever (C) on that control cage to the right.
6. If a hotspot must move to the left, move the
adjustment lever on that control cage to the left.
7. When the control cages are in correct position,
tighten the clamp levers.
To stop the product
WARNING:
collector until the product is fully stopped.
1. Push the button (A) to close the valves for the
abrasive material.
B
2. Push the button (B) to stop the blast motors. The
indicator in the button comes on to show that the
blast motors are off.
3. Release the lever for up and down movement to stop
the winches.
4. Turn the ON/OFF switch on the product to the OFF
position.
5. Disconnect the power plug from the power supply.
6. Remove the abrasive material from the separator.
To remove abrasive material from the
Refer to
product on page 23 .
2149 - 001 - 02.11.2023
C
B
A
Do not stop the dust
A
7. Stop the dust collector. Refer to the operator's
manual of the dust collector.
To remove abrasive material from the
product
1. Put a tarp below the abrasive material seal.
2. Make a note of the positions of the valves for the
abrasive material.
3. Remove the valves for the abrasive material. Refer
To remove and install the hopper and the valves
to
for the abrasive material on page 29
23
Publicité
