Publicité
7. After 2 m/6.5 ft., close the valves for the abrasive
material and stop the product. Refer to
product on page 23 .
8. Do a check of the blast pattern. Adjust the blast
pattern if it is necessary. Refer to
pattern on page 22 .
9. Operate the product to the top and then release
the movement lever and close the valves for the
abrasive material.
10. Turn the handle on the 2-way valve to decrease the
suction (A). The product releases from the surface.
11. Move the rigging system (B) to the right. Refer to
the operator's manual for the rigging system for
instructions.
2149 - 001 - 02.11.2023
To stop the
To adjust the blast
B
12. Turn the handle on the 2-way valve to apply suction
(C). The product attaches to the surface.
13. Operate the product down and open the valves for
the abrasive material during the movement.
14. If the product does not move straight down, turn the
tracking adjustment control to adjust the movement
to the left or right.
A
CAUTION:
Only adjust the left and
right movement in very small increments.
The product must be below the rigging
system at all times.
C
21
Publicité
