Publicité
7. Push the ON button (B) to start the blast motors. The
indicator on the button comes on.
B
To operate the product
WARNING:
below the product. A safe distance is bigger
than the length of the steel wire rope that is
used when you operate the product.
WARNING:
operation only. Do not move the product on
horizontal surfaces during operation.
WARNING:
is straight below the rigging system at all
times during the operation.
WARNING:
wire ropes are not damaged before you
operate the product.
WARNING:
certificate validity of the steel wire ropes,
the rigging system, the winches and the
shackles before you operate the product.
WARNING:
ropes to prevent them from rusting. Do not
use any lubricants that contain molybdenum
disulphide (MoS2) or PTFE.
20
Stay away from the area
This product is for vertical
Make sure that the product
Make sure that the steel
Do a check of the
Lubricate the steel wire
1. Make sure that you have done all procedures in
do before you operate the product on page 13 .
2. Start the dust collector. Refer to the operator's
manual of the dust collector.
3. Let the product attach to the surface.
4. Start the product. Refer to
page 19 .
5. With the remote control, operate the product up and
open the valves for the abrasive material during the
movement.
6. Read the amperage value on the remote control
display and make sure that the load is equal on the 2
blast wheels. Adjust the load if it is necessary. Refer
To operate the valves for the abrasive material on
to
page 13 .
To
To start the product on
2149 - 001 - 02.11.2023
Publicité
