Sony BVU-950 Manuel D'opération page 50

Review the edit.
To edit the next scene
After completing an edit-recording, review the edit.
Press the REVIEW button. The REVIEW lamp lights up and then the picture will be
reproduced by the recorder in the same manner as it is when editing. Use the monitor
connected to the recorder to check the edit. When the review is finished, the tape
returns to the OUT point, then stops.
To stop review
Press the STOP button.
With completion of editing for one scene, search for the next points. Perform the
editing in the same manner as described before. *
To change the preroll time duration
The duration for the preroll is factory-preset to five seconds, but this can be changed
if necessary.
See "DIAL MENU OPERATION" and the maintenance manual to change.
To change the duration, do not set the duration longer than the period between the
beginning of the recorded portion of the tape and the IN point. While the tape is
running from the preroll start point to the first IN point, the time code or CTL signal
must be reproduced for editing.
The preroll time for the automatic editing is selected with the recorder.
To quickly locate an IN or OUT point (Cue up)
First, press the PLAYER or RECORDER button. Then, press the PREROLL button and
the IN or OUT button at the same time.
When the IN button is pressed, the tape travels to the IN point, and when the OUT
button is pressed, to the OUT point. Then it stops.
* It is not necessary to enter an IN point on the recorder
to proceed with the next editing. See '""Continuous
Editing' for details.
46 (E)