Publicité
Les langues disponibles
Les langues disponibles
AUDIO IN (input) connectors (XLR 3-pin)
Supply audio signals from microphones or other audio sources to these connectors.
¢) AUDIO IN LEVEL (audio input level)/600 ohm termination selectors
("
a
AUDIO IN LEVEL selection
For Right -—
oS.
CMRIevEr To mo
I—For Left
OFF ON 009)
[OFF ON(6009)}
sila: avin | da
ou tba: daa
SE IEE BES
:
(; LOW
rior
LOW
_HIGH
)
Ld
|
i
i.
600 ohm
termination
selection
L
J
Set to the appropriate positions according to the level of the audio signals supplied to
the AUDIO IN connectors @. The level for the channels R (CH-1) and L (CH-2) can be
set independently.
LOW:
—60 dB (for microphone input)
HIGH:
+4 dB (for line input)
Select the termination for the incoming signals when the selectors are set to HIGH.
ON:
600 ohms
OFF:
10 kilohms
24)
EXT TBC (external time base corrector) switch
Selects an external time base corrector when a BKU-901
plug-in time base corrector
(optional) is not installed.
ON:
Set to this position to use with a stand-alone time base corrector.
OFF:
Normally, set to this position if a time base corrector is not used.
e When this selector is set to ON and a BKU-901
is installed, the BKU-901 will be
used instead of the externally connected time base corrector.
@)
FRAMING
SERVO switch
ON:
Normally set to this position. The framing servo-mechanism will be activated
when a signal is supplied to the VIDEO IN connector @ or to the REF VIDEO IN
connector @.
OFF:
When
using a prerecorded tape whose recorded signal was not framing servo-
controlled, the edited picture may
break up at the edited point. Should
this happen,
set this switch to OFF and the FRAMING
lamp located on the control panel goes
out.
21 (E)
Publicité
