Publicité
Les langues disponibles
Les langues disponibles
Sub-control panel
This panel is behind the lower half of the control panel. See the next page to view
the sub-control
panel.
@ INT TBC selector
@ CHARACTER switch
(
INT TBC
am
BYPASS
,
ON
AUTO
@ DOLBY NR switch
CHARACTER
DOLBY
NR
N
REMOTE-2 (24P)
ON
—
=
@%) REMOTE-1 (9P)/
REMOTE-2 (24P)
OFF
OFF
REMOTE-1 (9P)
selector
CHARACTER
switch
Normally, set to OFF. Set to ON to superimpose the title characters or the time code
when the unit is in the dial menu operation mode.
INT TBC (plug-in time base corrector) selector
This selector is activated when a BKU-901 time base corrector (optional) is installed in
the BVU-950.
BYPASS:
This will by-pass the time base corrector.
ON:
Signals are always time base corrected.
AUTO:
Signals except those in the record, E-E and edit modes are time base
corrected.
Be sure to supply a reference signal to the REF VIDEO IN connector located on the
connector panel when a BKU-9071 is installed.
DOLBY NR (Dolby noise reduction) switch
Use this switch for audio recording.
ON:
with the Dolby NR system
OFF:
without the Dolby NR system
When playing back, this is controlled automatically so it need not be set.
REMOTE-1
(9-P)/REMOTE-2 (24-P) selector
Selects another VTR or another compatible unit to be connected to the REMOTE-1
or
-2 connector.
REMOTE-1:
Another compatible unit connected to the REMOTE-1
connector (9-pin)
located on the connector panel is selected.
REMOTE-2:
Equipment connected to the REMOTE-2 connector (24-pin) located on the
connector panel is selected.
16 (E)
Publicité
