Sony BVU-950 Manuel D'opération page 70

How to use commands
To execute a desired command, follow the same procedure as for the character setup;
turn the search dial so that the desired command blinks and then press the SET
button.
The function of each command is as follows:
f sa
SET TCPO TLPO LD ST Command menu
cS 9
SET
Turn the search dial until the command blinks and then press the SET button to
execute the SET command. When the SET button is pressed, the title characters will
be superimposed on the VTR picture.
TCPO
This is to set the position of the time code on the display. Use 1 to 9 for small
characters, and 1 to 5 for large.
0: Erase the time code display*
1 to 9 (or 5): Set the position of the time code
f. oon
*Do not set to 0 to superimpose time code.
66 (E)