Publicité
Les langues disponibles
Les langues disponibles
Safety and Regulatory Information
Safety and Regulatory Information
This procedure requires the user to send SCPI commands to the instrument. Connect to
the instrument via LAN or USB. Use the Keysight IO Libraries to send SCPI commands.
General Information
The equipment is for industrial use.
Equipment operators are subject to all applicable safety regulations. Along with the warning and safety
notices in this manual, all relevant safety, accident prevention, and environmental regulations must
also be followed. In particular, the operators of the equipment:
Must be informed of the relevant safety requirements.
l
Must have read and understood the operating manual before using the equipment.
l
Must use the designated and recommended safety equipment.
l
The following general safety precautions must be observed during all phases of operation of this
instrument. Failure to comply with these precautions or with specific warnings or instructions
elsewhere in this manual violates safety standards of design, manufacture, and intended use of the
instrument. Keysight Technologies assumes no liability of the customer's failure to comply with the
requirements.
Safety Warnings
A WARNING notice denotes a hazard. It calls attention to an operating procedure, practice, or the like
that, if not correctly performed or adhered to, could result in personal injury or death. Do not proceed
beyond a WARNING notice until the indicated conditions are fully understood and met.
Should network communication issues occur, the instrument settings shown in the
Browser Web Control page may not represent the actual state of the instrument. This
may result in unexpected hazardous voltages on the output and sense connections that
could result in personal injury, death, or damage to a device under test. Before touching
the output or sense connections or connecting to a device under test, always verify the
state of the instrument.
Product Grounding
The instrument is a Class 1 product and is provided with a grounding-type power cord
set. The instrument chassis and cover are connected to the instrument electrical ground
to minimize shock hazard. The ground pin of the cord set plug must be firmly connected
to the electrical ground (safety ground) terminal at the power outlet. Any interruption of
the protective earth (grounding) conductor or disconnection of the protective earth
terminal will cause a potential shock hazard that could result in personal injury or death.
6
Keysight AC6800B Series Operating and Service Guide
Publicité
