Publicité
Les langues disponibles
Les langues disponibles
OUTPut:INHibit:MODE LATChing|LIVE|OFF
OUTPut:INHibit:MODE?
This command only applies when option AC68BFIU (the Fault Inhibit interface board) is
installed in the AC source.
Sets the operating mode of the remote inhibit digital pin. The inhibit function shuts down the output in
response to an external signal on the Inhibit input pin. The Inhibit mode is stored in non-volatile
memory. You can specify the polarity of the remote inhibit digital pin using
[SOURce:]DIGital:PIN:POLarity
Parameter
Typical Return
LATChing|LIVE|OFF
LATC,LIVE, or OFF
Sets the inhibit input to Live mode: OUTP:INH:MODE LIVE
LATChing - a logic-true signal on the Inhibit input causes the output state to latch OFF. The output
remains disabled until the Inhibit input is returned to logic-false and the latched INH status bit is
cleared by sending the OUTPut:PROTection:CLEar command or a protection clear command from the
front panel. Note that the output remains disabled after the protection is cleared and must be re-
enabled with the OUTPut ON command to turn it on again.
LIVE - allows the enabled output to follow the state of the Inhibit input.
OFF - the Inhibit input is ignored.
The inhibit mode is stored in non-volatile memory.
OUTPut:PON:STATe RST|RCL0|AUTO
OUTPut:PON:STATe?
Sets the power-on output state.
Parameter
RST|RCL0|AUTO
Set the power-on state to the *RST state: OUTP:PON:STAT RST
RST specifies that the instrument powers on in a state equivalent to *RST.
RCL0 loads the state stored in state storage memory location 0.
AUTO specifies that the instrument powers on in the power-down state. The output state is always off.
This parameter is not affected by
This parameter is saved in nonvolatile memory.
Keysight AC6800B Series Operating and Service Guide
POSitive|NEGative.
Typical Return
RST, RCL0, or AUTO
*RST
or *RCL.
3 SCPI Programming Reference
147
Publicité
