Publicité
Les langues disponibles
Les langues disponibles
DIGital Subsystem
The Digital subsystem has just one command.
This command only applies when option AC68BFIU (the Fault Inhibit interface board) is
installed in the AC source.
[SOURce:]DIGital:PIN:POLarity POSitive|NEGative
[SOURce:]DIGital:PIN:POLarity?
Sets the polarity of the remote inhibit digital pin. POSitive means a logical true signal is a voltage high
at the pin. NEGative means a logical true signal is a voltage low at the pin.
Parameter
Typical Return
POSitive|NEGative
POS or NEG
Sets the digital pin to negative polarity: DIG:PIN:POL NEG
The pin polarities are saved in non-volatile memory.
Keysight AC6800B Series Operating and Service Guide
3 SCPI Programming Reference
127
Publicité
