Keysight AC6800B Serie Guide D'utilisation Et D'entretien page 155

SYSTem Subsystem
The SYSTem subsystem controls instrument functions that are not directly related to output control,
measurement, or status functions. Note that IEEE-488 Common commands also control system
functions such as state management.
SYSTem:BEEPer[:IMMediate]
Issues a single beep.
Parameter Typical Return
(none) (none)
Issue a single beep: SYST:BEEP
This command overrides the current beeper state . You can issue a beep even if the beeper is turned off
by SYSTem:BEEPer:STATe.
Programmed beeps may be useful for program development and troubleshooting.
SYSTem:BEEPer:KCLick ON|1|OFF|0
SYSTem:BEEPer:KCLick?
Disables or enables the click tone heard when you press a front-panel key.
Parameter Typical Return
ON|1|OFF|0 0 (OFF) or 1 (ON)
Disable front-panel key click: SYST:BEEP:KCLick OFF
The front-panel key click and instrument beeper settings do not affect each other.
This parameter is not affected by
SYSTem:BEEPer:STATe ON|1|OFF|0
SYSTem:BEEPer:STATe?
Disables or enables the beep heard when an error is generated.
Parameter Typical Return
ON|1|OFF|0 0 (OFF) or 1 (ON)
Disable the beeper state: SYST:BEEP:STAT OFF
The front-panel key click and instrument beeper settings do not affect each other.
A beep is always emitted (even with beep state OFF) when
This parameter is not affected by
Keysight AC6800B Series Operating and Service Guide
*RST or *RCL.
*RST or *RCL.
3 SCPI Programming Reference
SYSTem:BEEPer is sent.
155