Publicité
SWINGARM
5. Install:
Relay arm 1
Bolt (relay arm) 2
Plain washer 3
Nut (relay arm) 4
To swingarm.
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Do not tighten the nut yet.
6. Install:
Swingarm 1
Pivot shaft 2
NOTE:
Apply the molybdenum disulfide grease on
the pivot shaft.
Insert the pivot shaft from right side.
7. Check:
Swingarm side play a
Free play exists → Replace thrust bear-
ing.
Swingarm up and down movement b
Unsmooth movement/binding/rough
spots → Grease or replace bearings,
bushes and collars.
8. Install:
Bolt (connecting rod) 1
Plain washer 2
Nut (connecting rod) 3
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Do not tighten the nut yet.
9. Install:
Plain washer 1
Bolt (rear shock absorber-relay arm) 2
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Insert the bolt from right side.
5 - 57
CHAS
85 Nm (8.5 m · kg, 61 ft · lb)
53 Nm (5.3 m · kg, 38 ft · lb)
Publicité
