Publicité
ENGINE OIL LEVEL INSPECTION
NOTE:
Align the projection a on filter guide with the
hole b in air filter case.
ENGINE OIL LEVEL INSPECTION
NOTE:
Never remove the oil tank cap just after
high speed operation. The heated oil could
spurt out. causing danger. Wait until the oil
cools down to approximately 70 ˚C (158 ˚F).
3 - 14
9. Apply:
Lithium soap base grease
On the matching surface a on air filter
element.
10. Install:
Air filter element 1
Washer
Fitting bolt
2 Nm (0.2 m · kg, 1.4 ft · lb)
1. Stand the motorcycle on a level surface.
When checking the oil level make sure that
the motorcycle is upright.
Place the motorcycle on a suitable stand.
WARNING
2. Idle the engine more than 3 minutes
while keeping the motorcycle upright.
Then stop the engine and inspect the oil
level.
3. Remove:
Oil tank cap 1
INSP
ADJ
Publicité
